Replacement Filter Set For Triple Under The Counter and Triple Direct Line Systems
This Filter Set is for both the Triple Under The Counter System and Triple Direct Line System.
Stage 1: 1um (Micron) Sediment Filter:
This removes particles from the water down to 1 micron.
Stage 2: Premium KDF Filter:
This filter contains activated carbon mixed with KDF. The KDF has anti-bacterial properties and prevents the growth of bacteria within the filter, thus extending its life to twice that of standard activated carbon.
Stage 3: Pleated Filter Cartridge (0.2 Micron):
This has replaced the Ultra Filteration Membrane as it dramatically reduces flush times making the system quicker to install and easier to maintain.
This is a physical barrier that will not allow bacteria to pass through.
Also Avaliable on Takealot.com
If you would like to Purchase this product using a Credit Card Online, or with eBucks, or with Discovery Miles some of them are also avaliable on Takealot.com*.
Please follow the link below:
*Please Note That the Prices and Specifications of the products supplied through Takealot may differ from those on Filtershop's Website.
Flushing the system:
This is done by running water through the system until the preservative cannot be detected in a sample glass of water. If you are seeing this in your water after a new installation, flush and test until no hints of the dust can be detected. Please note if there is a white colour to the water that settles out towards the top of the glass, this is most likely caused by tiny air bubbles in the water. This is caused by the Pleated Filter, and is completely normal. This should subside over time as excess air in the system is removed. The air bubbles in the water will not effect the quality of your drinking water.
How to remove / replace your filter:
Start by unscrewing the filter housing from the filtration unit. This is done by rotating the filter housing in a clockwise direction (see diagram below). The filter housing will separate from the filtration unit, and you are now free to remove the filter cartridge from the filter housing. To replace your filter: insert the new filter into the filter housing. Be sure to remove any protective plastic wrapping from the filter cartridge before placing them into the filter housing. Check that the black rubber O-rings are in place and fit well on the filter housing. If they seem perished or loose you may want to purchase new O-rings to ensure a good seal. As an option you can add a little bit of Vaseline on the O-rings to make them seal better, this will make it easier to open next time. Take note of any rubber seal on top of the KDF . This will need to face upwards to connect and seal at the top of the filter housing. It is important that this is done correctly as the system will not work optimally if the filters are installed incorrectly. Now that your filter is in the housing, bring the housing to the filtration unit and begin to screw the two together. This is done by rotating the filter housing in a anti-clockwise direction. We recommend you tighten by hand as this is usually sufficient to maintain a good seal. If however, leaks are detected, the housing spanner can be used to tighten the filter housings until a good seal is achieved. (Check O-rings are correctly in position before tightening with the spanner) Please take care not to over-tighten the filter housings. This could strip the housing thread and cause your system to fail. It will also make it more difficult to replace filters in the future if they are over-tightened. The UF filter cartridge may require more tightening as the rubber seal on these cartridges are made from a harder rubber.
When to change your filters:
Filter life span is determined by the quality of the source water that runs through them. So if your source water is of a very bad quality, your filters will be doing more “work” to clean the water that is flowing through them. Thus depleting sooner than filters running under good water conditions. So in short each end-users filter requirements will be different as their source waters are different. We advise you check your filters on a monthly basis after initial install to get a feel for the quality of the water in your area. You will see for example, that the stage 1 filter (1um Sediment) is turning brown from the outside towards the centre over a period of 12 months. If this is the case, your water quality is exceptionally good as these filters generally only have a life span of 4 - 12 months filtering average South African water. If your water quality is very poor you may be replacing the 1um sediment filter every 2 months. So visual inspection of your filters is the best way to determine when to change your filters. For the KDF and Pleated filter the “symptoms” are a little different. These filters are depleted once bacteria has colonised them completely. So in testing you will want to see if any traces of bacteria can be detected. This is done by physically inspecting the filter cartridges. You want to check for a “slime” on the filters. This is a slippery substance and will feel similar to a mucus of sorts. If this is present on your filter cartridge then bacteria has colonised the filter and a replacement cartridge is required.When changing the KDF Cartridge it is the ideal time to replace the Ceramic Filter and possibly the 1 Micron Sediment as well. The Pleated Filter can also become clogged, if you are noticing a much lower flow rate on your product water side of the system, this could be the cause. In which case the Pleated Filter cartridge may need to be replaced before the KDF.
Triple Under The Counter Standard Replacement Filter set
0.2 Micron Pleated Filter has replaced the Ultra Filtration Membrane as it dramatically reduces flush times making the system quicker to install and easier to maintain.
Adding a Housing Spanner
Over time the housing can become tight, and difficult to open by hand. If you do not already have one available to open the housings, we would recommend adding a housing spanner.
The Housing Spanner will allow you to gain more "purchase" on the housing, allowing you to open it more easily.